Updated 9/7/2011
The eMS-Pro has four logic level (5 volt) spark outputs. These signals can be used to drive a QuadSpark if you are using ignition coils that do not have built in ignition modules, like our IGN-4 or factory Ford coils.
QuadSpark on an eMS-Pro
Set the DIP switches 2-1, 2-2, 2-3, and 2-4 to the On position.
| Spark output | AMPSEAL pin | QuadSpark wire |
| A | 8 | Yellow |
| B | 9 | Orange |
| C | 10 | Dark green |
| D | 11 | Blue |
Software settings required:
Under ignition settings:
- Set Spark Output Inverted to “No.” Setting this wrong can overheat the QuadSpark or damage the coils.
Enable dwell control and adjust as needed to match the coils you are using. Set the dwell at a very low value to start with and increase it slowly. Back it off if the case becomes hot to the touch.