Cart

Quick Links

Tools

The right tools make all jobs easier. Browse our selection of crimpers, lead benders, stimulators, jumpers, pin removal tools & more.EPA, CARB & Emissions Disclaimer- All ECU's are for race purposes only. It's your responsibility to remain in compliance with all federal, state, provincial, or other laws that apply to you.

Showing all 5 results

  • Ratcheting Crimper for Weather Pack Connectors, 10-12 Gauge

    Ratcheting Crimper for Weather Pack Connectors, 10-12 Gauge

    5 out of 5
    $87.00

    Need to crimp your Weather Pack connectors to heavier gauge wire? This one will crimp 10 and 12 gauge. Like our other tool, this is a quality, American made crimper. It doesn't have the holding block like on the smaller tool however, and it needs two sepa...

    Add to cart
  • Weather Pack Pin Removal Tool

    Weather Pack Pin Removal Tool

    5 out of 5
    $6.00

    This tool makes de-pinning Weather Pack connectors a simple snap or poke. Just pop the seal retainer off, poke the tool in from the terminal side, slippingĀ the tool over the terminalĀ all the way in to release the latch, and pull the wire out from the...

    Add to cart

  • Anti-Static ESD Protection Wrist Strap

     $5.49

    Anti-Static ESD Protection Wrist Strap Protect your electronics from Electrostatic Discharge (ESD) during assembly or modification. Attach this wrist strap by connecting the clip to a good ground point and you'll safely discharge all static electricity...

    Add to cart
  • Lead Bending Tool

    Lead Bending Tool

    5 out of 5
    $5.50

    Lead Bending Tool This inexpensive lead bending tool will come in very handy when building up your MegaSquirt kit or any electronics kit. It helps you to quickly bend the leads of 1/4 and 1/2 watt resistors, diodes, capacitors, inductors, etc to the ex...

    Add to cart

  • D-Sub Connector Pin Removal Tool

    5 out of 5
    $6.00

    Need to remove a pin from one of our assembled MegaSquirt harnesses? These little tools are what you need to release the pins from a D-Subminiature connector so you can pull the wire out.

    Add to cart