Showing all 6 results
-
MegaSquirt V3.0 Case
$46.00This is the enclosure as used with the MegaSquirt-III V3.0 ECU. It includes cutouts for the SD card, USB port, and MS3X expansion card. This is the case included with all of our current MS1, MS2, and MS3 V3.0 ECU kits. It is required if you are upgradin...
Add to cart -
MegaSquirt V3.57 Case
$46.00This is the enclosure as used with the MegaSquirt-III V3.57 ECU. It includes cutouts for the SD card, USB port, and MS3X expansion card. This is the case included with all of our current MS1, MS2, and MS3 V3.57 assembled ECUs. It is required if you ...
Add to cart -
MegaSquirt GPIO Black Anodized Case
$48.00GPIO board case. This one has an AMPSEAL cutout on one end, and the other end blank. You may drill a hole if using the stereo jack for serial communication, or use the AMPSEAL for that. Note that these cases are a bit of a tight fit - we recommend solderi...
Add to cart -
MS Relay and Power Board – Case Bottom and Endplates
$27.00Case Bottom with Flanged Endplates Machined for MegaSquirt Relay Board Case is brushed aluminum finish. Black anodize finish is no longer available.
Add to cart -
MegaSquirt GPIO – Heat Sink Only
$9.50Included is a Heat Sink Machined for MegaSquirt GPIO Board Part # GPIO-HS Similar to our V3.0 heat sink, but this one is made specifically for the GPIO board from 1/8" aluminum.
Add to cart -
MegaSquirt PCB3.0 – Heat Sink Only
$10.00Heat Sink Machined for MegaSquirt PCB version 3.0 Part# MSx30-HS
Add to cart
