$9.99
-
Modkit used to build a relay control circuit, suitable for switching a relay on/off and controlling fans, VVT, VTEC, TVIS, anything a relay can control.
Usable on the PCBv3.0, v3.57 or PCBv2.2 ECUs
Information and an example of how to implement this circuit on the PCBv3 board can be found here.
V3.0 relay control mod installation (with pictures)
How much current can this output handle?
There are no questions yet, be the first to ask something for this product.
Who's Your MapDaddy? - MapDaddy 4 Bar MAP Sensor with Barometric Correction Ready to rock your ride handling up to 44psi of BOOST! New version has a 4 bar MAP sensor combined with a 1 bar barometric pressure sensor to improve barometric pressure re...
Add to cart
These are the parts needed for the 'TIP120 PWM idle valve' mod. If you are installing all optional components on the v3 heat sink (leaving no extra space for this transistor there) then you can drill a hole in your case and use it as your heat sink or a...
Add to cart
10-pack of wire jumpers in 5 colors. These fit 0.1" headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Add to cart
Note: This has been replaced by our Coil Driver Kit. The power transistor that Bosch uses in their own ECUs is now available to you! This is a 'mod kit' for installing a BIP373 in a Megasquirt, or replacing an older or damaged VB921 with the much impr...
Read more
The Zeal Engineering Daughterboard was designed and developed by Ken Culver, one of the authors of the MS2/Extra and MS3 firmware. We're proud to now offer this daughter card in kit form. It was originally developed for the FC RX-7, but we have found it...
Add to cart
High current ignition driver kit with heatsink designed for the DIYPNP ECU. It includes the OnSemi EcoSPARK IGBT. This is the same high current ignition driver as used in many of our current ECU products as well as the QuadSpark ignition module, after...
Add to cart
Reviews
There are no reviews yet.