$3.99
Six 1k 1/4w resistors, and four 470ohm 1/4w resistors. Perfect for use as ‘pullup resistors’ for your MS ECU modding needs.
These can be used for several of the mods described in some of our car-specific install articles listed on the site.
NOTE: This kit is for PCBv3.0, v3.57 and PCB2.2 MegaSquirt ECUs
Who's Your MapDaddy? - MapDaddy 4 Bar MAP Sensor with Barometric Correction Ready to rock your ride handling up to 44psi of BOOST! New version has a 4 bar MAP sensor combined with a 1 bar barometric pressure sensor to improve barometric pressure re...
Add to cart
Give your Megasquirt the ability to drive a boost control solenoid double up it's duty as an electronic boost controller. Includes all parts required to build the MSnS-E boost control circuit on your V2.2, V3.0, or V3.57 PCB, including FET, resistors, hea...
Add to cart
Note: This part supersedes the Bosch BIP373. OnSemi EcoSPARK IGBT, perfect for use as a high current ignition driver and can be used as Q16 in your v3.57 or v3.0 MegaSquirt build. This is the same high current ignition driver as used in many of our...
Add to cart
USB A to Mini B cable. Use this with the following products: MS3Pro EVO MS3Pro Ultimate CAN-EGT MS1 or MS2 V2.2 or V3.0 modified with DLP-TXRX mod kit We include this cable with MS3Pro EVO & Ultimate. Does not fit MS3 V3.0 or V3.57.
Add to cart
These are the parts needed for the 'TIP120 PWM idle valve' mod. If you are installing all optional components on the v3 heat sink (leaving no extra space for this transistor there) then you can drill a hole in your case and use it as your heat sink or a...
Add to cart
Note: This has been replaced by our Coil Driver Kit. The power transistor that Bosch uses in their own ECUs is now available to you! This is a 'mod kit' for installing a BIP373 in a Megasquirt, or replacing an older or damaged VB921 with the much impr...
Read more
1 review for MegaSquirt Pull-up Resistors Mod Kit