$48.00
-
GPIO board case. This one has an AMPSEAL cutout on one end, and the other end blank. You may drill a hole if using the stereo jack for serial communication, or use the AMPSEAL for that. Note that these cases are a bit of a tight fit – we recommend soldering the AMPSEAL from the top to get it started, with the board in the case, the endplates on, and the lid off. If you are using the stereo jack, you must drill the endplate. Color is black anodized.
Where is this case made?
There are no questions yet, be the first to ask something for this product.
Use this application package to set up your GPIO (General Purpose Input/ Output) board (GPIO-K) for MegaShift. Includes the 4L60E and 4L80E build guide items. We've also included some extra components in case you're looking to change some features or ...
Add to cart
This is a starting point for your GPIO (General Purpose Input/ Output) project. Because of the number of ways the GPIO can be built, we've opted to offer it as a basic kit to which you can add application packages to customize it for the MegaShift code, E...
Add to cart
This is the enclosure as used with the MegaSquirt-III V3.0 ECU. It includes cutouts for the SD card, USB port, and MS3X expansion card. This is the case included with all of our current MS1, MS2, and MS3 V3.0 ECU kits. It is required if you are upgradin...
Add to cart
Single EGT input kit using AD595AQ amplifier chip. Intended for use on the GPIO board, but could be used anywhere you wish to take our EGT probes or other K-type thermocouples and convert their signal to a 0-5 volt output. This includes enough parts to po...
Add to cart
This is a very basic and incomplete starting point for building a GPIO (General Purpose Input/ Output) kit. It includes the main board, all SMD components soldered on, AMPSeal connector, and all the AMPSEAL pins, each crimped to a short length of TXL wire...
Add to cart
Heat Sink Machined for MegaSquirt PCB version 3.0 Part# MSx30-HS
Add to cart
Reviews
There are no reviews yet.