Description
Simplify your AFM/MAF removal process with our comprehensive kit designed for use with AMP|EFI ECUs. When removing the air flow meter, you’ll often need to relocate the air temperature sensor, as many MAF units have this sensor built in. Our kit provides all the essential components to help you seamlessly install an Intake Air Temperature (IAT) Sensor elsewhere in your inlet tubing.
Kit Includes:
- (1) 3/8″ NPT Aluminum Bung (weld-on) for secure installation
- (1) Open Element IAT Sensor (uncrimped with three pins; includes one extra pin for peace of mind)
- (8) Feet of Wire (ample length to position your sensor within 4 feet of your AFM/MAF connector)
- (3) Male Pins (fits various AFM connectors; one extra pin included for convenience). These pins work with most AFM/MAF connectors; we recommend using a Weatherpack crimper for optimal results, although pliers can suffice for a temporary fix.
For detailed instructions on how to remove your AFM/MAF using this kit, please refer to your MSPNP Manual found [HERE].
Customer reviews
Rated 4.5 out of 5 stars
2 reviews
3 stars
0
0 %
2 stars
0
0 %
1 star
0
0 %
Only logged in customers who have purchased this product may write a review.
What is its resistance vs temperature curve?
- If you are connecting this to a device that supports 3 point calibration (all MegaSquirt units do), use these numbers if your device does not have a standard GM temperature sensor calibration curve.
- 7000 ohms at 48 degrees F
- 1930 ohms at 87 degrees F
- 560 ohms at 146 degrees F
I am using it with a device that requires a voltage vs temperature curve. What data do I enter?
- This sensor outputs resistance, not voltage. You will need additional, external circuitry to convert its output into a voltage, and the voltage will depend on the design of the external circuit.
Can I buy the connector separately?
- Yes. You can order a connector here: GM IAT sensor crimp connector. This is a somewhat different style connector from the one we ship with the sensor, but will connect to the sensor without any problem.
Where exactly should I install this on my engine?
- We do not recommend threading it into the intake manifold except for supercharged engines where the supercharger attaches directly to the manifold. For all other applications, we recommend installing this sensor in the part of the intake system directly upstream of the throttle body. The reason is that the intake manifold often transfers heat to the sensor by conduction at a faster rate than it transfers heat to the incoming air. While there are ECU settings to compensate for this, mounting the sensor where it does not absorb so much heat will often make tuning easier.
2 reviews for IAT Temperature Sensor Kit – Aluminum Bung