$2.50
-
Bulkhead fittings, just like those used in the MSPNP Gen 2 and MS3Pro PNP line. It’s made from black nylon, fits 1/8″ vacuum line on the outside and 1/8″ inside, and measures about 1 1/4″ long. Use to replace broken fittings, or if you’re running your MAP sensor or boost gauge line through the firewall to prevent rubbing.
There are no questions yet, be the first to ask something for this product.
[3 Pack] Mica insulator / hardware kit for TO-220 components. Used for V3.0 / V3.57 Q9 and Q12, as well as for BIP373 coil drivers. Heat sink compound recommended. Includes 3 of each: mica insulators mounting screws nuts lockwasher i...
Add to cart
10-pack of wire jumpers in 5 colors. These fit 0.1" headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Add to cart
1/8" vacuum Y-fitting, as included in the MSPNP and Mustang plug and play packages. This is made of clear polycarbonate. Maximum pressure 125 psi. This plastic is tough enough to take 275 degree F engine temps, and won't crack even if exposed to Siberian ...
Add to cart
Metalized plastic backshell for the DB15 spare I/O connector, as used on our DIYPNP, VVTuner, and V3.57 boards.
Add to cart
To make sure you can't accidentally switch the upper and lower harnesses, the MS3X harness uses a male DB37 connector instead of a female one. We've packaged a DB37 male solder cup connector and a metalized plastic backshell for your MS3X builds. See t...
Add to cart
Reviews
There are no reviews yet.