$34.99
Use this application package to set up your GPIO (General Purpose Input/ Output) board (GPIO-K) for MegaShift. Includes the 4L60E and 4L80E build guide items. We’ve also included some extra components in case you’re looking to change some features or try out your own input and output circuits.
GPIO board case. This one has an AMPSEAL cutout on one end, and the other end blank. You may drill a hole if using the stereo jack for serial communication, or use the AMPSEAL for that. Note that these cases are a bit of a tight fit - we recommend solderi...
Add to cart
This is a starting point for your GPIO (General Purpose Input/ Output) project. Because of the number of ways the GPIO can be built, we've opted to offer it as a basic kit to which you can add application packages to customize it for the MegaShift code, E...
Add to cart
Included is a Heat Sink Machined for MegaSquirt GPIO Board Part # GPIO-HS Similar to our V3.0 heat sink, but this one is made specifically for the GPIO board from 1/8" aluminum.
Add to cart
10-pack of wire jumpers in 5 colors. These fit 0.1" headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Add to cart
This is a very basic and incomplete starting point for building a GPIO (General Purpose Input/ Output) kit. It includes the main board, all SMD components soldered on, AMPSeal connector, and all the AMPSEAL pins, each crimped to a short length of TXL wire...
Add to cart
Single EGT input kit using AD595AQ amplifier chip. Intended for use on the GPIO board, but could be used anywhere you wish to take our EGT probes or other K-type thermocouples and convert their signal to a 0-5 volt output. This includes enough parts to po...
Add to cart
2 reviews for GPIO Application Kit – MegaShift